U2113 BMW Fault Code

Description:

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden BMW TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the BMW PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

U2113 Code Symptoms :

If your vehicle failed a U2113 test and the U2113 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U2113 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look : Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.

Diagnosis And Repairing U2113

U2113 OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix U2113 code ?

• Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
• Failures of clutch motion/travel sensors.
• Erratic camshaft position due to low oil pressure
• EVAP system hose leaking

In most cases, the TCM is integrated into a single housing with the BMW PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately.

In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.